Sliding doors have emerged as one of the most viable solutions to the problem areas crossing functionality.
They possess a number of qualities that recommend them as a replacement for conventional doors. First of all, this type of door opening side shows the great advantage compared with conventional doors on hinges that open either inside or outside. Regardless of the direction of openness, functionality of the space that will suffer because conventional doors.
Steps:
1.Zona fitting new door was carefully measured, first on the floor. After being established position that will slide rail door, it was fixed to the floor with holtzsuruburi.
2.Dupa dropping it, by design, was established track position at the ceiling. After marking the second track was also fixed to the ceiling with the same type of screws.
3.Placa MDF was cut to the warehouse from which it was purchased. Spot but found that the dimensions of doors should be a few inches smaller. Consequently, plaques were measured.
4.Dupa bookmarking data points required dimensions, lines were drawn on sheets to be cut. They were clearly marked to guide cutting.
5.Urmand previously drawn lines, MDF boards are cut to size. The surgery was done carefully to avoid producing waste they generate additional costs.
6.La lower extremities widths of the two doors were mounted wheels. They were first placed on signs derived from measurements, then the screws were fixed
7.Urmand same steps, and guides were mounted on top of door widths. All these were purchased as a set SKM 80.
The settlement positions
8.Inainte doors were installed and stopper. Their position was carefully calculated so that the two doors to stop at 2 mm from the wall.
9.La Finally, the two doors were installed large mirrors. They are useful because they are in the dressing room, but also because it gives the impression of space.
They possess a number of qualities that recommend them as a replacement for conventional doors. First of all, this type of door opening side shows the great advantage compared with conventional doors on hinges that open either inside or outside. Regardless of the direction of openness, functionality of the space that will suffer because conventional doors.
Steps:
1.Zona fitting new door was carefully measured, first on the floor. After being established position that will slide rail door, it was fixed to the floor with holtzsuruburi.
2.Dupa dropping it, by design, was established track position at the ceiling. After marking the second track was also fixed to the ceiling with the same type of screws.
3.Placa MDF was cut to the warehouse from which it was purchased. Spot but found that the dimensions of doors should be a few inches smaller. Consequently, plaques were measured.
4.Dupa bookmarking data points required dimensions, lines were drawn on sheets to be cut. They were clearly marked to guide cutting.
5.Urmand previously drawn lines, MDF boards are cut to size. The surgery was done carefully to avoid producing waste they generate additional costs.
6.La lower extremities widths of the two doors were mounted wheels. They were first placed on signs derived from measurements, then the screws were fixed
7.Urmand same steps, and guides were mounted on top of door widths. All these were purchased as a set SKM 80.
The settlement positions
8.Inainte doors were installed and stopper. Their position was carefully calculated so that the two doors to stop at 2 mm from the wall.
9.La Finally, the two doors were installed large mirrors. They are useful because they are in the dressing room, but also because it gives the impression of space.
